What to read before either driver pits
Tower labelHow to use it
Position (P1, P2, P3…)Pick two drivers on the same lap. Remember their three-letter abbreviations so you can follow them when their rows move.
IntervalRead a driver's row for the time back to the car one place ahead. If another car slots between your pair, the interval on the lower row now measures a different battle.
Gap to leaderBoth rows use P1 as the reference. If one rival is 8 seconds behind P1 and the other is 11 seconds behind, they are about 3 seconds apart, even with a car between them.
+1 LAPThe deficit to the leader is a whole lap. Read the unit before comparing it with a gap shown in seconds.
PIT or IN PITThe driver is in the pit lane. Watch the cars still at racing speed move up the tower, then find the driver's row again after pit exit.

Follow one pair through both stops

Suppose the chasing driver pits first. Note the interval to the rival ahead just before pit entry. The chaser may drop several rows while the crew changes tyres. Even a quick tyre change costs track position because the driver also slows for entry, travels through the speed-limited lane and accelerates back onto the circuit.

On the chaser’s first lap back out, find the rival who stayed out. If the broadcast gives an estimated pit loss, compare it with that rival’s lead over the chaser. A lead smaller than the estimate suggests the cars could swap places when the rival stops. Traffic or a slow stop can change the outcome.

Watch pit exit when the second driver stops. If the original chaser comes past before the rival rejoins, the early stop has gained the place. That is a successful undercut. If the rival emerges ahead, the chaser’s faster lap may still have narrowed the gap. Check their order and their next comparable timing update.

Frequently Asked Questions

Why does a safety car change the pit loss estimate?

Cars still on track slow down, so a driver in the pits can lose less ground. Under a virtual safety car (VSC), drivers must meet minimum times. Under a safety car (SC), the field gathers behind the safety car and gaps can shrink as cars catch the queue. Recheck the gap before using an estimate made at full racing speed.

Why are several cars in the pit lane under a red flag?

A red flag suspends racing. Drivers normally return to the pit lane under the suspension procedure. Follow race control’s restart order and watch which driver is ahead when racing resumes.

Can the finishing order change after the chequered flag?

Yes. At the finish, completed laps determine the order, with crossing order separating cars on the same lap. If a pit lane incident is under investigation, the stewards can review video and issue a penalty. Time added to a driver’s result can move a close rival ahead. Check the FIA race classification for the outcome.

Pit wall vocabulary
TermWhat to watch
In-lapThe lap on which the driver enters the pits. Follow the rival who stays on track while the stopping driver slows.
Out-lapThe lap on which the driver leaves the pits. Watch whether traffic holds up the car on fresh tyres.
OvercutA driver stays out after a rival pits and tries to gain enough time to emerge ahead after their own stop.

Rule editions and sources

  • Fédération Internationale de l’Automobile (FIA) · 2026 Formula 1 Regulations, Section B (Sporting), Issue 09 · Grand Prix races in the 2026 FIA Formula One World Championship. Sprint and qualifying sessions have separate provisions. Timing tower labels are broadcast conventions. — FIA 2026 Formula 1 Regulations — Section B [Sporting], Issue 09